Table tops are a furniture piece that must be attached firmly to the table legs to prevent wobbling and collapsing. There are different types of mechanisms that are used for this purpose, but one of the easiest and most reliable options is the use of Figure 8 Table Top Fasteners.
These fasteners are simple to install and hold the table top securely in place. This guide will highlight the steps required to use these fasteners effectively to help you complete your DIY project successfully.
1. Understanding Figure 8 Table Top Fasteners
Figure 8 Table Top Fasteners are designed to hold a table top and base together without requiring any visible screws, clips, or brackets. These fasteners have a screw hole in the center of a round or rectangular plate, and a projecting loop or flange on the opposite side.
The plates are installed on the underside of the table top using screws that are screwed through the screw holes. The loops or flanges on the other side of the plates then hook onto the table legs or apron, firmly holding the table top in position.
2. Choosing the Right Fastener Size
The size of the fastener you need will depend on the thickness of the table top and the projection of the flange or loop. Most Figure 8 Table Top Fasteners come in different sizes such as 1 inch, 1-1/4 inch, or 1-1/2 inch.
Measure the thickness of your table top and buy a fastener that provides at least 3/8 inch of projection to hook onto the table base. For instance, if the table top is 1 inch thick, choose a fastener with at least 1-3/8 inch projection.
3. Preparing the Table Top and Base
Before you install the fasteners, prepare the table top and base by marking the position where the fasteners will be attached. You can use a pencil and tape measure to mark the spots or use an alignment jig or template for accuracy.
Ensure that the marks are even and aligned, and that the table top is perfectly centered on the base. You can also sand or level the bottom surface of the table top or base to ensure that they are flat and even.
4. Installing the Fasteners
To install the fasteners, first, position the plate on the underside of the table top with the screw hole in the center of the plate aligned with the mark on the table top. Use a drill with a bit that is slightly narrower than the screw size to drill a pilot hole through the screw hole in the plate and into the table top.
Then, partially insert a screw into the pilot hole and align the plate with the mark on the table top. Insert the remaining screws and tighten them carefully to avoid damaging the plate or table top.
Next, flip the table top over and hook the flanges or loops onto the table base, ensuring that the fasteners are centered and aligned with the marks on the base. Tighten any screws or bolts that secure the table base to the fasteners.
5. Testing and Adjustment
Finally, test the stability and levelness of the table top by pressing down on each corner and side of the top. If the top is wobbling or tilted, adjust the position of the fasteners or reposition the table top until it is perfectly level.
In conclusion, Figure 8 Table Top Fasteners offer a simple and effective way to attach table tops to bases without visible hardware or complicated mechanisms. Understanding the purpose, size, installation, and testing of these fasteners is critical to ensure that your table is secure and stable. Use this guide to help you integrate these fasteners into your next DIY project.
.